MIMAKI INDIA PRIVATE LIMITED

Starting point and ending point don't meet or cutting line doesn't get cut when operating the tangential cutter.

  • Go to [CUT CONDITION] and check [START CORRECTION] and [END CORRECTION].

1. Select Tool [B (CUTTER)].

  For details, see “SELECTING A TOOL [TOOL SELECT]” in Operation Manual.

2. Perform [TEST CUT].
  See how the test cut comes out and go to [START/END CORRECTION] under
  [CONDITION] and adjust the upper or lower limit of the cutter.

  For details, see “SETTING CUTTING CONDITIONS [CONDITION]”
  in Operation Manual.

  If you make the value for [START CORRECTION] bigger, it starts to cut front side of
  the starting point.
  If you make the value for [END CORRECTION] smaller, it completes the cutting at
  the back side of the ending point; it will make easier for you to take off the cut
  object easily.



When the starting point and ending point do not meet in circle cutting:
  Check [CIRCLE θ COR].
  The value should vary by the thickness of the work or the degree of hardness,
  thus make an adjustment to meet the size of the circle.
  * If a problem occurs in R60 circle, then adjust the correction value for [50 < R < 100].


Procedure:
1) Turn [ARC θ] to [Enable] before you run the function, [CIRCLE θ COR].

2) Run the function, [CIRCLE θ COR].
  For details, see “[TOOL ADJUST] > [CIRCLE θ CORRRECT]” in Operation Manual.



Return to Content

PAGETOP